Page 1 of 1
windsurf boards and circular saws.
Posted: Mon Jun 01, 2020 10:21 pm
by jim mckenzie
Has anyone taken a circular saw to a carbon wrap board? I can't decide if it's going to cut nicely or shatter into a mess.
Re: windsurf boards and circular saws.
Posted: Mon Jun 01, 2020 10:27 pm
by KUS
jim mckenzie wrote:Has anyone taken a circular saw to a carbon wrap board? I can't decide if it's going to cut nicely or shatter into a mess.
seems to work just fine....A whole lot less carbon than you would think
Posted: Mon Jun 01, 2020 11:05 pm
by nanmoo
I've used a fatmax handsaw and and circular saw. Both worked quite well but one was louder.
Posted: Tue Jun 02, 2020 6:49 am
by jim mckenzie
Thanks Kus and Nanmoo. Looks good. We had so much fun tow foiling I'm going to make a surf-tow board out of an old Roberts slalom for days when it's not windy.
Posted: Tue Jun 02, 2020 9:50 am
by nanmoo
jim mckenzie wrote:Thanks Kus and Nanmoo. Looks good. We had so much fun tow foiling I'm going to make a surf-tow board out of an old Roberts slalom for days when it's not windy.
I've done that with two SUP's that had to be cut in half for warranty. Enjoy!
